Making Sunshine and Shadow Quilt

Making Sunshine and Shadow Quilt

Now, that the fabrics and the quilting equipment are ready, I am prepared to create the quilt. My next step is to take photos of each piece of fabric and design my new quilt. After two attempts, I came up with this Sunshine and Shadow patchwork pattern with borders:

Sunshine and Shadow quilt pattern on the computer

All fabrics are cut into strips 5 1/2” wide to make five inch squares after the quarter inch seam allowance (on each side).

Strips of fabric prepared for Sunshine and Shadow quilt

I keep all of my sewing machine settings unchanged until all patchwork is complete. It is very important to have exactly the same seam allowance to line up the blocks very neatly later.

Sewing machine walking foot

When all strips were stitched together, the seams were ironed to one side. Great care was taken to press the seams very flat without stretching the material.

Precise alignment of the quilt blocks makes a big difference in the end.

I cut one strip of fabric at the right angle to make the first row of single square blocks 5 1/2” wide.

A strip of quilt squares

After one strip was cut, the remaining sheet of the fabric strips was sewn shut to form a tube. That last seam must be pressed in the same direction. Because of this circular arrangement, the Sunshine and Shadow patchwork is sometimes called “Trip around the World.”

Tube of strips prepared for cutting

Next step is to cut the tube perpendicular to the seams to make several rings, five-and-a-half inch wide.

And here is the big secret. Each ring should be ripped at one seam, but not the same seam. I rip the rings in a staggered fashion to create the diagonal arrangement.

Strips of squares ripped in staggered fashion

I sew the strips together with the same unchanged 1/4” seam allowance setting.

Sewing the strips of fabric

The technique of stitching the strips together is called “chain sewing.” (At least I don’t have to do chain sawing like I did a few years ago when I learned how to cut wood with a chain saw. Whew!)

It always helps to have a little helper to double check your work.

Quality check

The Quality Manager approved my work. It’s all in the right order.

Quality Manager's approval

After all strips are stitched together, I press all seam allowances in the same direction.

Seam allowances in the back side of the patchwork

The four quarters of the quilt are done separately to be assembled into one large Sunshine and Shadow quilt top.

If you read the previous page about the fabric selection for this quilt, you may remember this bright and cheerful print designed by Angela Anderson. I used this border along the periphery of the quilt.

I didn’t use it as a continuous piece. I broke the design with additional quilt blocks to make it more appealing.

Eight quilt blocks were made to adorn the border: four green blocks for the corners of the quilt, and four brown-and-orange blocks were used in the middle of the border on all four sides.

Quilt blocks for the border

When the border was finished, I carefully ironed it to flatten the seams.

Quilt borders

When I work on my patchwork, I don’t see the entire quilt. It’s too large to be spread out on the work surface. And I try not to pull and shake the quilt top as it may cause the undesirable stretching and skewing of the quilt blocks.

Part of quilt on the ironing board

After all of the patchwork is done and the quilt top is ready, I start working with this beautiful backing fabric from Hancock’s of Paduckah, KY. I already prepared the solid piece of fabric ahead of time. It’s been prewashed, pressed, and trimmed.

Quilt backing fabric

The patchwork was finished at last. The back side of the patchwork will never be seen again.

The next step is to sandwich the top, batting, and backing and secure the quilt.I don’t use basting sprays on my quilts. Good old fashioned safety pins do the job perfectly well.

Sandwich quilt is pinned to secure the layers

All three layers are sandwiched into one piece of my cozy creation.

They are spread out gingerly with no pulling or tugging.

Quilt prepared for stitching

The quilt is ready for the next step, which is stitching. We are going to take a break though. It’s been a long day. Ask the Quality Manager how hard we worked. But may be not just yet. The QM has crashed after the long and arduous day.

Resting after the hard work

See you next time 🙂

Previous Step: Fabric Palette for the QuiltNext Step: Stitching the Quilt
Connect with me

Leave a Reply